A cap mockup places a logo on the front panel of a photographed cap, following its curve and the light, so it looks printed or applied rather than pasted.
- Follows the curve of the front panel
- Takes the photo's own light
- Runs offline on your Mac
From any photo to a mockup, in minutes
No template to find, no PSD to buy. Take a photo you like, and these four steps make it the mockup.
Open your cap photo
Front, three-quarter or worn: one photo per angle.
Choose the Curved shape
Fit the layer to the front panel. The edges snap to the contours of the photo.
Drop your logo
Mask the seam or the brim if they pass in front.
Set the light and export
Match the shading of the panel, then export.
Curved, then fabric
A structured cap is a smooth curve: use Curved. A dad hat or a beanie folds: switch to Fabric and raise Folds.
A patch with some relief
The Emboss finish raises a logo slightly and moves its highlights with the light. It suggests a patch or a raised print. It is not an embroidery simulation, and we would rather say so.
Questions
Is there a free cap mockup?
Muckup does not ship stock photos: it turns the photo you already have into the mockup, in a few minutes. Your own shot, a client's product photo, or a free photo from Unsplash or Pexels. The Muckup beta is free.
Does it simulate embroidery?
No. Muckup gives a printed or slightly raised look with Emboss. Stitch texture is not simulated.
Can I put the logo on the side as well?
Yes. Add a second layer for the side panel, with its own design or the same tag.